Changes

|-

|-

|width = 210px|Berm height (mm)

|width = 210px|Berm height (mm)

|Sometimes referred to as the bowl depth

|Ponding depth, maximum (e.g. 300 mm), sometimes referred to as 'bowl depth'

|-

|-

|Surface roughness (Manning’s n)

|Surface roughness (Manning’s n)

|Lower numbers indicate less surface obstruction and result in faster flow

|Lower numbers indicate less surface obstruction and result in faster flow

Suggested ranges:

Suggested ranges:

* [[Turf: List|Mown grass]] (dependent on density) 0.03 – 0.06<ref name = SWMM> Oregon State Univ., Corvallis. Dept. of Civil, Construction and Environmental Engineering.; Environmental Protection Agency, Cincinnati ONRMRL. Storm Water Management Model Reference Manual Volume I Hydrology (Revised). 2016:233. https://nepis.epa.gov/Exe/ZyPURL.cgi?Dockey=P100NYRA.txt  Accessed August 23, 2017.</ref>

* [[Turf|Mown grass]] (dependent on density) 0.03 – 0.06<ref name = SWMM> Oregon State Univ., Corvallis. Dept. of Civil, Construction and Environmental Engineering.; Environmental Protection Agency, Cincinnati ONRMRL. Storm Water Management Model Reference Manual Volume I Hydrology (Revised). 2016:233. https://nepis.epa.gov/Exe/ZyPURL.cgi?Dockey=P100NYRA.txt  Accessed August 23, 2017.</ref>

* [[Stones]] 0.03 – 0.05

* [[Stone]] 0.03 – 0.05

* Planted (highly dependent on density) 0.05 – 0.15

* Planted (highly dependent on density) 0.05 – 0.15

|-

|-

|Depth of filter media

|Depth of filter media

|-

|-

|Porosity (fraction)

|Porosity of filter media

|Suggest range 0.35 – 0.4 unless otherwise tested

|Suggest [[Bioretention media storage|0.35]] unless otherwise tested

|-

|-

|Field capacity (fraction)

|Field capacity (fraction)

|Suggested value 0.03 <ref name = SWMM/>

|Suggested value 0.03 <ref name = SWMM/>

|-

|-

|Conductivity (mm/hr)

|Hydraulic conductivity (mm/hr)

|Suggested range 25 – 250 mm/hr

|Suggested range 25 – 250 mm/hr

|-

|-

|Depth of storage aggregates layer

|Depth of storage aggregates layer

|-

|-

|Void ratio

|Porosity of storage reservoir aggregate

|Suggest range 0.35 – 0.4 unless otherwise tested

|Suggest value 0.4 unless otherwise tested

|-

|-

|Seepage rate (mm/hr)

|Seepage rate (mm/hr)

|-

|-

|Clogging factor

|Clogging factor

|?

|Maybe up to 0.5 to account for some anticipated maturation.

|-

|-

|Design drawdown time (hrs)

|Design [[drainage time]] (hrs)

|Also known as '[[drainage time]]'

|Maximum permissible time to fully drain the storage reservoir.

|-

|-

!colspan = "2" align = center"|'''Drain (underdrain)'''

!colspan = "2" align = center"|'''Drain (underdrain)'''