2,216
edits
Changes
Jump to navigation
Jump to search
Line 91:
Line 91:
→Wellhead Protection Areas (WHPAs)
====Wellhead Protection Areas (WHPAs)====
====Wellhead Protection Areas (WHPAs)====
A Wellhead Protection Area (WHPA) is an area located on the ground surface that denotes a specific zone within a known aquifer where fresh groundwater flows to a pumping well. Any detrimental activities/actions that take place in this zone may contribute to pollutions that can infiltrate into the underlying soil below and in turn contaminate said groundwater source for private and municipal wells alike - hence undertaken in this area may release pollutants that could seep into the soil and contaminate the groundwater used by both domestic and municipals wells. As a result, these areas require high levels of monitoring, protection and enforcement. Accordingly, this area warrants greater protection.
The risk to groundwater quality at the well site is determined by the rate at which a specific pollutant/contaminant can infiltrate and travel to the well and the time it would take to remediate the contaminant from the water supply by trained municipal water operators.
''For example, if a chemical spill occurs a considerable distance away from a well, an assessment will be required. The assessment considers whether the spilled chemical will reach the well and how long it will take; whether the chemical is a health risk or an aesthetic parameter; whether the concentrations of the chemical at the well will exceed the provincial standard; and whether the existing treatment process is adequate to remove or reduce the concentrations of that chemical. If sufficient time is available, a mitigation system may be installed to limit the movement of the chemical to the well or the water treatment process may be modified to adequately lower the concentrations. If time is available, the risk to the water supply is lower.
Accordingly, for the purposes of source protection planning, the wellhead protection area has been divided into the following parts:
WHPA-A – an area of 100 metre radius around the wellhead
WHPA-B – the zone through which it takes groundwater to travel between two years and the 100 metre distance
WHPA-C – the zone through which it takes groundwater to travel between five and two years
WHPA-D – the zone through which it takes groundwater to travel between 25 and five years
WHPA-E – the area on ground surface through which surface water flows in two hours to a point close to the well. This wellhead protection area is only delineated when studies have shown that surface water can relatively easily seep through the soil and impact the quality of the water at the well. This situation is known as groundwater under the direct influence of surface water, or a GUDI well''
====Intake Protection Zones (IPZs)====
====Intake Protection Zones (IPZs)====