Infiltration: Testing

Four Step Process

Soil infiltration testing is a four-step process to obtain the necessary information for stormwater management planning and design. The four steps include:

1. Background Evaluation

• Based on available published and site specific data;
• Includes consideration of proposed development plan;
• Used to identify potential BMP types, locations and soil test locations;
• Done prior to field work; and
• On-site soil tests may be done to identify/screen potential BMP locations.

2. Test Pit or Soil Boring Observations

• Includes multiple testing locations;
• Provides an understanding of sub-surface conditions; and
• Identifies limiting conditions (e.g., aquitard, bedrock or water table elevations).

3. Infiltration Testing

• Must be conducted on-site;
• Various testing methods are available; and
• Different testing methods for screening versus verification purposes.

4. Design Considerations

• Determination of a suitable infiltration rate for design calculations; and
• Consideration of desired BMP drawdown time.

Test Pit or Soil Boring Observations

Test pits or soil borings provide information regarding the soil horizons and overall soil conditions both horizontally and vertically in that portion of the site. Multiple observations can be made across a site at a relatively low cost and in a short time period.

Test pit excavations or soil borings should extend to a depth of between 2.5 - 5 m below ground surface or until bedrock or fully saturated conditions are encountered. It is important that the tests provide information related to conditions at least 1.5 m below the proposed bottom elevation of the infiltration BMP. Test pit trenches should be benched at 1 m depth intervals for access and infiltration testing.

At each test location, the following conditions should be noted and described:

• Soil horizons (upper and lower boundary);
• Soil texture and colour for each horizon;
• Color patterns (mottling) and observed depth;
• Depth to water table (if encountered);
• Depth to bedrock (if encountered);
• Observations of pores or roots (size, depth);
• Estimated type and percent coarse fragments;
• Hardpan or other limiting layers; and
• Strike and dip of soil horizons.

---

Best management practice. State of the art methods or techniques used to manage the quantity and improve the quality of wet weather flow. BMPs include: source, conveyance and end-of-pipe controls.

The upper surface of the zone of saturation, except where the surface is formed by an impermeable body.

Subsurface water level which is defined by the level below which all the spaces in the soil are filled with water; The entire region below the water table is called the saturated zone.

The rate at which stormwater percolates into the subsoil measured in inches per hour.