Difference between revisions of "Exfiltration trenches"

From LID SWM Planning and Design Guide
Jump to navigation Jump to search
m
Line 18: Line 18:
===Site Topography===  
===Site Topography===  
Systems cannot be located on natural slopes greater than 15 %. The gravel bed should be designed with gentle slopes between 0.5 - 1 %.
Systems cannot be located on natural slopes greater than 15 %. The gravel bed should be designed with gentle slopes between 0.5 - 1 %.
==Design==
===Geometry and Site Layout===
Gravel beds in which exfiltration systems are installed are typically rectangular excavations with a bottom width between 600 and 2400 mm (GVRD, 2005). The gravel beds should have gentle slopes between 0.5 to 1%.


==Performance==
==Performance==

Revision as of 01:10, 7 November 2017

Overview[edit]

Exfiltration trenches are similar to infiltration trenches but differ primarily in the the manner in which stormwater is delivered to the trench. Runoff enters infiltration trenches directly by infiltration from the surface. In exfiltration systems, surface runoff is collected by drainage inlets and delivered to the trench via subsurface perforated pipes.

Exfiltration systems can be thought of as long infiltration trenches or linear soakaways that are designed for both conveyance and infiltration of stormwater runoff. They are underground stormwater conveyance systems designed to attenuate runoff volume and thereby, reduce contaminant loads to receiving waters. They are composed of perforated pipes installed in gently sloping granular stone beds that are lined with geotextile fabric that allow infiltration of runoff into the gravel bed and underlying native soil while it is being conveyed from source areas or other BMPs to an end-of-pipe facility or receiving waterbody.

Exfiltration systems can be used in place of conventional storm sewer pipes, where topography, water table depth, and runoff quality conditions are suitable. They are suitable for treating runoff from roofs, walkways, parking lots and low to medium traffic roads, with adequate pretreatment.

A design variation can include perforated catchbasins, where the catchbasin sump is perforated to allow runoff to infiltrate into the underlying native soil.

Perforated pipe systems can also be referred to as pervious pipe systems, exfiltration systems, clean water collector systems and percolation drainage systems.

Planning[edit]

If properly located, designed and maintained, perforated pipe systems can greatly reduce runoff volume while having little or no surface footprint, which helps to conserve highly valued developable land.

Systems should be located below shoulders of roadways, pervious paving or grass swales where they can be readily excavated for servicing. An adequate subsurface area outside of the 4 m setback from building foundations and suitable distance from other underground utilities must be available.

Site Topography[edit]

Systems cannot be located on natural slopes greater than 15 %. The gravel bed should be designed with gentle slopes between 0.5 - 1 %.

Design[edit]

Geometry and Site Layout[edit]

Gravel beds in which exfiltration systems are installed are typically rectangular excavations with a bottom width between 600 and 2400 mm (GVRD, 2005). The gravel beds should have gentle slopes between 0.5 to 1%.

Performance[edit]

Template:Exfiltration: Performance

External resources[edit]

https://www.chijournal.org/C390