Difference between revisions of "Notation"

From LID SWM Planning and Design Guide
Jump to navigation Jump to search
(Created page with " ;q :infiltration rate in units of length per time. (before or after application of safety factor?) ;SCF :Safety correction factor (dimensionless) ;R<sub>a</sub> :Existing...")
 
Line 1: Line 1:
;m
:run of side slopes in channel cross sections (length, but usually expressed as a ratio in relation to rise. e.g. where side side slopes = 1:3.5, m = 3.5)


;q
;q
:infiltration rate in units of length per time. (before or after application of safety factor?)
:infiltration rate in (length per time, usually mm/hr) (before or after application of safety factor?)


;SCF
;SCF
Line 7: Line 9:


;R<sub>a</sub>  
;R<sub>a</sub>  
:Existing rise of swale gradient
:Existing rise of swale gradient (length, usually m)
 
;R<sub>b</sub>
:Rise of compensation gradient for an enhanced swale (length, usually m)

Revision as of 18:58, 27 September 2017

m
run of side slopes in channel cross sections (length, but usually expressed as a ratio in relation to rise. e.g. where side side slopes = 1:3.5, m = 3.5)
q
infiltration rate in (length per time, usually mm/hr) (before or after application of safety factor?)
SCF
Safety correction factor (dimensionless)
Ra
Existing rise of swale gradient (length, usually m)
Rb
Rise of compensation gradient for an enhanced swale (length, usually m)