Notation

A_c

Area of the catchment, whole contributing drainage area (usually in m²)

A_p

Area of the practice e.g. footprint area of a bioretention cell (usually in m²)

d

Depth e.g. of an infiltration practice (units of length, usually m)

L

Length, e.g. of a reach, channel or swale (usually in m)

m

run of side slopes in channel cross sections (length, but usually expressed as a ratio in relation to rise. e.g. side slopes = 1:3, so m = 3)

n

Manning's coefficient (unitless) (Note: for clarity porosity is being expressed as 'void ratio' and sharing the notation '

q

infiltration rate in (length per time, usually mm/hr) (before or after application of safety factor?)

Q_p

Peak flow in units of volume per time (e.g. m³/s)

R_a

Existing rise of swale gradient (length, usually m)

R_b

Rise of compensation gradient for an enhanced swale (length, usually m)

RVC_T

Runoff volume control target (as outlined by MOECC, units are mm)

S

Longitudinal slope (m/m, i.e. dimensionless)

SCF

Safety correction factor (dimensionless)

t

time (usually in hrs)

V_R

Void ratio, as usually applied to aggregates and yard materials. In this guide, it is also applied to native soils in lieu of porosity (unit for both are vol/vol, i.e. dimensionless)

y

Depth of water (length, usually m or sometimes mm)

The land draining to a single reference point (usually a structural BMP); similar to a subwatershed, but on a smaller scale.

The total surface area upstream of a point on a stream that drains toward that point. Not to be confused with watershed. The drainage area may include one or more watersheds.

A shallow excavated surface depression containing prepared filter media, mulch, and planted with selected vegetation.

A shallow constructed channel, often grass-lined, which is used as an alternative to curb and channel, or as a pretreatment to other measures. Swales are generally characterized by a broad top width to depth ratio and gentle grades.

The porosity (n) of a mixture is the ratio of the volume of void-space to the total or bulk volume of the mixture. It is closely related to the concept of void ratio (e) where void ratio is the ratio of the volume of void-space to the volume of solids. n = Volume of voids/Total volume of mixture = e/(1+e)

The void ratio (e) of a mixture is the ratio of the volume of void-space to the volume of solids. It is closely related to the concept of porosity (n) where porosity is the ratio of the volume of void-space to the total or bulk volume of the mixture. e = Volume of voids/Volume of solids = n/(1-n)

The rate at which stormwater percolates into the subsoil measured in inches per hour.

Vegetated open channel, with check dams; designed to convey, treat and attenuate stormwater runoff.

The portion of water precipitated onto a catchment area, which then flows as surface discharge from the catchment area past a specified point.

Water from rain, snow melt, or irrigation that flows over the land surface.

The void ratio (e) of a mixture is the ratio of the volume of void-space to the volume of solids. It is closely related to the concept of porosity (n) where porosity is the ratio of the volume of void-space to the total or bulk volume of the mixture. e = Volume of voids/Volume of solids = n/(1-n)

A broad category of particulate material used in construction, including sand, gravel, crushed stone, slag, recycled concrete and geosynthetic aggregates, and available in various particulate size gradations.